EVY is a MIDI effect. It does not make a sound on its own, and it does not care what receives its notes. That is the useful part: one held chord can drive a synth, a drum rack or a sampler, and the rhythm controls apply to all three.
One track for EVY, one for the sound
Put EVY on an empty MIDI track. Do not add an instrument to that track. Create a second track with the instrument, drum rack or sampler you want to hear, then set its MIDI input to the EVY track. In Ableton Live, that is MIDI From set to the EVY track, with the channel set to Post FX.
Arm the EVY track and hold a chord. The notes EVY generates travel to the second track. Any MIDI effect placed after EVY on the first track processes the generated line before it reaches the instrument.
Into a synth: melody
Load a mono or poly synth on the second track and play a chord on the EVY track. EVY chooses among those pitches; it never adds one you are not holding. Set Rate to 1/16 for a moving line, or 1/8 for something with more air. Length decides how much of each step is filled. Breath introduces rests, which matter more than extra notes when the synth has a long release.
For a bass part, hold two or three notes in a low register and lower the rate. The same network that produces a fast top line will produce a slower figure when the grid is slower. The note choice is still limited to the chord.
Into a drum rack: pattern
A drum rack maps incoming notes to pads. Hold the notes that correspond to the pads you want EVY to use. If C1 is a kick and D1 is a snare, holding C1 and D1 gives EVY those two sounds as its vocabulary. Add a closed hat and an open hat if you want the pattern to move across the kit.
This is where Random and Repetition change the feel most. Low random and high repetition produce a stable pattern with small variations. More random pushes the hits around the kit. Breath removes steps, which is often what makes a pattern feel played.
Into a sampler: triggers
A sampler behaves like an instrument whose notes are slices or one-shots. Map the held notes to the slices you want. Keep Length short so each trigger is clean, and use Rate to choose the grid. This works for vocal chops, found sounds, percussion loops and single hits.
If the sampler has a one-shot mode, turn off looping first. A MIDI note that arrives twice in quick succession can otherwise restart the same slice before it has played. EVY's own Length control is the better place to shape the gate.
Setting a starting point
A useful first patch is simple: rate 1/16, length around half a step, breath low, random low, repetition in the middle. Route it to a synth and hold a four-note chord. Then change one control at a time. The network's memory needs a few bars before its behaviour is clear; give it eight or sixteen and listen to how the phrase returns.
The destination is not a preset. It is the instrument you already trust. EVY supplies the notes and the timing; the synth, kit or sampler supplies the sound.
The manual covers install, routing and every parameter in detail.